how to avg clear unitall off of the boot menu

The pass or fail result is reported using the storage system's LEDs. This option can be useful when you are attempting to rescue data off a disk during a disaster recovery. WARNING: Use the tech support boot mode only when instructed to do so by a NETGEAR technical support representative. OS reinstall boot mode also resets some settings on your storage system, such as Internet protocol settings and the administrator password, to defaults. The OS reinstall boot mode can be useful when the system crashes and corrupts some configuration files. Reinstalls the firmware from the internal flash to the disks. If you want to start the factory default process immediately, press the Backup button during the 10-minute time-out period.After the 10-minute time-out period, the factory default process begins. If you want to reset the system to factory default settings, do not power off your system.The system powers down safely without causing any data loss. If you want to cancel the factory default process, power off the storage system before the 10-minute time-out period ends.WARNING: The factory default reboot process resets the storage system to factory settings, erases all data, resets all defaults, and reformats the disk to X-RAID. After the disk test, a 10-minute time-out period begins. Initiates a short disk test that takes approximately 5 minutes. Initiates a normal boot process, just like booting using the Power button. Your storage system has the following boot modes: Use the boot menu to restart or troubleshoot your ReadyNAS storage system.

How to avg clear unitall off of the boot menu